1965 C337 "Alternator not charging" light

[JAG]

Dave,
Yes, it is a tight clearance. Without the sidewall in place, there is clearance, but it is close. I just double checked my part numbers, and it looks like I did order the tall ones...dammit. I ordered the 3TC7, not 3TC2!!!! Looks like I will be ordering those 3TC2 breakers today!!!! That should give me an extra 0.5".

Thanks for questioning me on that. When I fit it over the weekend, I was not happy with the clearance, but felt once the sidewall panel was it, it would give me some more...but if I can put in lower profile CB's, that is much better in the long run.

Yes, I am doing a dedicated Avionics Bus - the lower row (RH side of picture) will be the avionics bus, controlled by a Avionics master in the panel.

After seeing your pictures of the old CB panel, I looked at mine and could not believe how bad it was. Some smoke was definitely let out of that one wire on mine - not to mention the crappy aluminum bus bar...barely rated for the Skymaster system.
Jeff

[DrDave]

Jeff:

You may want to consider a spacer between the panel and the mounting holes. This would look like a license plate frame. I'll send you pictures. I would also encourage you to line the panel area with thin pieces of polycarbonate. The biggest offenders in your picture is the tie bars. The tie bar you have pictured should be good for 400 amps. I made the same mistake with the 3TC-7's the first time as well.

Dave

[JAG]

Dave,
The tie bar is good for 428 Amps...ha ha. Yes, I used a wide piece, however that does not add anymore height than a skinny one - but you are right, that is what makes it tight. I would love to see your pictures of it mounted - had considered some spacers or improvement of mounting it rather than just using the side panel as a "gasket".

Planning on a thin Lexan lining for it - installed on aircraft side of the panel. Especially for skin side and top (prevent FOD from dropping down into back of panel is paramount for me).
Thanks for the help!
Jeff

[DrDave]

I will take some pictures for you. The 3tc-2 breakers will make a big difference.
The jumpers can be at the far end of the bus. That way it won't be so busy up where the alternator leads attach.

Dave