Level flight requires slight right hand turn input

[hharney]

Does the airplane fly straight and level? Your concern sounds like the yoke is not centered?

[B2C2]

Hi herb

Yes once the yoke is turned slightly to the right it flies straight and level with the ball pretty much centered. I spoke to my mechanic about it and he said it is acting left wing heavy, which doesn't mean it's necessarily heavy on the left side, but probably has a slight difference in the apparent Angie of attack of the two wings. Given the amount Of Aileron input required about 1/8 of an inch or less effective difference between the two wings would probably do it. It doesnt look like there is any adjustment for this as there is on some cessnas that have a cam for adjusting the Angie of attack. Without making some careful measurements it would be hard to establish that this is the case.

Ben

[Kim Geyer]

You might have a mechanic check the rigging with the Robertson STOL manual. It says to rig the flaps per the cessna manual. then with the control lock in rig the left aileron to fair with the tip and the right aileron @ 1/4 inch above the tip.
Kim

[cessnadriver]

I have seen this in other Cessnas. My C172 had the problem, although this Cessna has the eccentric bushings in the trailing edge of each wings. I adjusted the left (LIGHT WING) full down and the right full up. I KNOW THIS ISN'T THE PROBLEM YOU MENTION, BUT LET ME FINISH MY EXPLANATION. After all these adjustments my IA noticed my left flap was NOT fully UP in the tract. I replaced the flap and plane flys straight! So my advice is to make certain that your flaps (on the high flying wing) is in FULL UP position.
FYI.
BILLS

[B2C2]

I will definitely check the Robertson manual for that aileron setting. 1/4 inch of upward deflection on the right aileron would probably fix most of whats going on. I have the manual but its currently at the shop with the plane and log books. In regard to the flap suggestion I have looked pretty carefully at the flap positions and they seem to be even on both sides.

[DrDave]

Wouldn't the simple thing be to have the rigging checked, in a methodical order, by someone that is experienced in airframe rigging? There are a number of people that have taken the CPA rigging course that could help out. It is so nice to fly a plane that is rigged correctly.

Dave

[B2C2]

I had the rigging redone about two years ago, but it did not effect the flight characteristics. At that time the mechanic used the Robertson manual, and he's pretty careful so I need to check it to see if in fact it recommends the aileron deflection. I will be back in the states next week and will look into it.