Front ram air heat exchanger control cable

[raykenyon]

Much appreciated--Ray

[Red Air Rambo]

Ok, if we are talking about the cable on the valve off the Janitrol Heat Exchanger, it runs down 1st attaching to an arm off the exchanger, then back to the battery, then up to a point on the firewall midway between the vacuum pump and inner (lower) starter contactor (should look like a quarter with a hole in the middle). Then thru the bottom of the avionics bay and into cabin behind the center console then parallels the defrost cable to the lever. FYI, mine is a 73.


--Brent

[raykenyon]

Hello Brent-
Planning to head down to the hanger tomorrow with your info in hand and see what I can figure out-thank you so much for taking the time to try to help.

Best-Ray

[Red Air Rambo]

Ray, if you need I can send pics, but I will need a phone number...still have a flip phone lol

[raykenyon]

Hey Brent-

didn't get down to the hanger today--plant problems--tomorrow I hope--cable goes back to the battery box--under the battery box?--and makes a 90 degree along the front bulkhead?

Ray

[Red Air Rambo]

90 degree bend at the front of the battery box then direct to the hole that is probably plugged between the vacuum pump and starter contactor.

[raykenyon]

Hello Brent---
Partial joy! I did find the hole through the front bulkhead located right where you said it was. It was completely filled with press. Sealant

Of course I can see the battery box. If it is possible to shoot a couple of cell phone pics (uh-oh-flip phone) of the cable at the batt. Box location- it would help a lot. Don,t mean to impose but I want to try to get this right. No problem either way-you have been a big help.

Thanks for all-Ray