|
|
|||||||
| Register | FAQ | Members List | Calendar | Today's Posts | Search |
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
GMAs... Mixture control stop on fuel pump.
GMAs, any advice on the stop pin Re: mixture control on the fuel pump as far as keeping it in place. Was o/h in 99, talked to them this am. Romulus MI. said to check housing for cracks, they say they sometimes use red loctite, did not see any traces of it.... Guy.... old72driver....
|
|
#2
10-01-02, 04:10 PM
|
|||
|
|||
Interesting.. I thought we had heard it all... but,....
this is intersting... I send a quree to cont engine as to what to do.. and as soon as I get it back I will pass it along... just wanted to let you know I did read your message... but, the pin actually backed out of its hole ... hmmmm interesting... G.M>GMAs
|
|
#3
10-01-02, 09:30 PM
|
||||
|
||||
|
Stop pin.......
Thanks GMAs, yes it backed out somewhere in cruise. must have been moving for some time. It got to a position where it was a new stop well lean of full rich and would not allow the mixture control to move forward at all. Guy....old72driver....
|
Linear Mode
