|
Register | FAQ | Members List | Calendar | Search | Today's Posts | Mark Forums Read |
Thread Tools | Rate Thread | Display Modes |
#1
|
|||
|
|||
Insight engine moniter
Brand new Insight engine moniter with harness including all new probes 5k.
|
#2
|
||||
|
||||
Is this the Insight G4 Twin?
__________________
Classic Searey and Skymaster 337D owner |
#3
|
|||
|
|||
Insight G4 twin
This unit is a G4 twin set up for a
1973 T337G |
#4
|
|||
|
|||
Engine Monitor
Hello
I have a FTB337G -1975 in Europe. I am thinking to install an engine monitor. Does The G4Twin give you Fuel quantity as primary ? Thanks Alain
__________________
Alain +41 79 266 2000 www.evazion.ch www.osud.ch www.Whitepod.com www.purplewings.ch |
#5
|
|||
|
|||
it does have a fuel computer but NOT as a primary unit
|
#6
|
|||
|
|||
G4
Hello
Thanks for your replay. So you need to insert the full quantity you have in your tanks and then the fuel computer will give you remaining fuel etc etc ? Yours have all document and certification ?
__________________
Alain +41 79 266 2000 www.evazion.ch www.osud.ch www.Whitepod.com www.purplewings.ch |
#7
|
|||
|
|||
yes fuel computer does that and I do have all the paperwork
|
#8
|
||||
|
||||
Insight G4 considerations
What does this G4 include?
There is the basic EGT CHT Then options for Fuel flow, which requires either dual sensors or interface to exisiting sensors Vibration, which requires RPM Engine power, which requires dual OAT The only cert as primary is to replace EGT and CHT, all other is 'advisory/supplemental' The advisory are better than the certified, but you can't pull the old ones out. --- From what I've found so far, 100% replacement options for primary gauges are 1. Some combination of multiple Garmin 275s (apparently $13k+ in parts) It looks like one would need 2-3 gauges. One for each engine then one for tanks? 2. Electronic international the electronics international 'CGR' suite $12k in parts Then maybe another $3-5k to install. It looks like it drops to $9k if you trade in, but that assumes you are using existing sensors already installed from prior engine analyzer. https://iflyei.com/wp-content/upload...ombo_Sheet.pdf 3. Or EI's twin package MVP package https://iflyei.com/product/mvp-50p-engine-monitor/ This requires panel cutting so install cost probably quite a bit more. I'm actively considering an engine analyzer, BUT.....that old 'cost/benefit thing
__________________
David Wartofsky Potomac Airfield 10300 Glen Way Fort Washington, MD 20744 |
#9
|
||||
|
||||
Still for sale?
__________________
David Wartofsky Potomac Airfield 10300 Glen Way Fort Washington, MD 20744 |
Thread Tools | |
Display Modes | Rate This Thread |
|
|