Skymaster Forum  

Go Back   Skymaster Forum > Messages
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Reply
 
Thread Tools Rate Thread Display Modes
  #1  
Old 05-16-18, 02:08 PM
cessnadriver cessnadriver is offline
Registered User
 
Join Date: May 2010
Location: Franklin, Pa.
Posts: 207
cessnadriver is on a distinguished road
Interconnected elevator trim to flaps

Hello all.
During a pre-flight I noticed my elevator trim does NOT automatically roll forward while bring up the flaps with the trim wheel rolled full down position. I went through the manual re-adjusted the fitting that is suppose to bump against the elevator trim stops. Afterwards I re checked to see if the trim wheel moved forward as required. It did one time. After that the trim did not move as it should. Has anyone else had this problem?
Thanks in advance.
Regards.
BILLS

Last edited by cessnadriver : 05-16-18 at 02:10 PM. Reason: grammar
Reply With Quote
  #2  
Old 05-17-18, 02:57 PM
hharney's Avatar
hharney hharney is offline
Rough Surface
 
Join Date: Jul 2002
Location: Michigan (8D4)
Posts: 1,944
hharney is on a distinguished road
Have not ever seen the problem Bill. In the right boom, inside access panel is the trim interconnect cable, at least that is where I have noticed it
__________________
Herb R Harney
1968 337C

Flying the same Skymaster for 41 years
Reply With Quote
  #3  
Old 05-22-18, 09:44 AM
cessnadriver cessnadriver is offline
Registered User
 
Join Date: May 2010
Location: Franklin, Pa.
Posts: 207
cessnadriver is on a distinguished road
Interconnected elevator trim to flaps

Hello ALL.
FYI.
I fixed the problem with the inter-connected flaps and elevator trim. It was a improper rigging.
BILLS
Reply With Quote
  #4  
Old 05-29-18, 11:42 AM
cessnadriver cessnadriver is offline
Registered User
 
Join Date: May 2010
Location: Franklin, Pa.
Posts: 207
cessnadriver is on a distinguished road
Question Interconnected elevator trim to flaps

Hello ALL-Again.
Well I thought I had the flap elevator trim fixed__GUESS NOT. I've gone through the procedure in the maintenance manual going on THREE TIMES! I can get the trim set at the proper degrees of trim UP and DOWN, then when I adjust the interconnect flap-trim I cannot get the proper DOWN TRIM. I only get about 5 degree, it should be 26 degrees, because of the STOP BLOCK #8 on the up cable. This is the block that presses up against the #9 block on the end of the push-pull solid wire cable connected to the Flap bell crank. DOES ANYONE HAVE EXPERIENCE WITH THIS?
Thanks for any and ALL help.
Regards, BILLS
Reply With Quote
Reply


Thread Tools
Display Modes Rate This Thread
Rate This Thread:

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

vB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump


All times are GMT -4. The time now is 04:40 AM.


Powered by vBulletin® Version 3.6.9
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.