Fuel selector valve

[edasmus]

Excellent work and fine post! Thank you for sharing. Amazing...

[TomM]

Awesome!!

Do you have the o-ring part numbers you can share? I would like to do mine as when the valve is off, the fuel from the port side main tank drains back into the reserve tank and then out the overflow. If both tanks are full, it will leak over 10 gallons in a week before the pressure is low enough to stop the flow. So I now I park it with full main tanks and empty reserve. I prefer to keep them all full.

Thanks!!

[Skymaster337B]

Before you overhaul the fuel valve check out Cessna Bulletin ME81-19.

[wslade2]

Service bulletin says to remove the ball from the port that is not connected so the valve can “operate in all temperatures.” My guess, some water gets behind the ball in that closed off cavity, freezes, jams the ball so it can’t be pushed back and that probably jams the cam and valve.

Thanks for noting that.

[JAG]

just following up on this thread - did you happen to have P/N's for the o-rings you could share?

Thanks,
Jeff

[wslade2]

Going to have to admit to a degree of disorganization here. Had a lot of 337 microprojects since then with stuff scattered around including o-rings, lots of o-rings.

But...I had bought a viton o ring assortment from Harbor Freight for various uses on my 337 project. For the shaft there was a perfect fit out of that assortment but can't recall which compartment with the exact measurements. I wrote down the measurements of the original shaft o-ring as 0.5" OD x 0.4" ID x 0.05" CS (cross section). Realize that's the compressed old o-ring measurements. Nothing out of that assortment, though, fit the ports with the balls. I'm pretty sure those were 5/16" ID x 7/16" OD x 1/16" CS (cross section) that I purchased online from the o-ring store. Again, all in viton as the parts manual specifies. Sorry for being a little scattered on that now.

I lubricated the shaft/o-ring with EZ Turn fuel lubricant (grease) available from Aircraft Spruce. My mechanic turned me on to this while dealing with some fuel fitting issues and it is designed to be used in high octane fuel environment.

Speaking of the o-ring store, they've been a life saver for o-rings. A fellow pilot with a piper Lance had a leaking fuel drain/valve unit due to the tiniest worn o-ring. No body had this o-ring, not even piper could help him, except buy used $3000 hardware off ebay (no-one wants to rebuild the unit). They were able to confer with mechanic and send an assortment of o-rings around the shaft size with finally one that ended up working.

[JAG]

Thanks - totally understand about the microprojects.

Jeff