|
|
|||||||
| Register | FAQ | Members List | Calendar | Today's Posts | Search |
 |
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
rubber trim on 337p door needed
It's not the actual door seal, its the trim that goes between the interior plastic around the door and the metal door frame. I replaced the plastics but the foam trim molding is history and needs replacing.
|
|
#3
04-06-17, 11:00 PM
|
|||
|
|||
|
rubber trim -
I have searched my parts manual and have not found the part. I don't know if it is original or added along the way. It dense foam, triangular in shape about 1/2 inch each side. I've searched a number of manufacturers for something similar without much luck. It was glued to the metal door frame and spanned the gap to the plastic trim. Any help appreciated.
|
|
#5
05-02-17, 06:50 PM
|
||||
|
||||
|
__________________
Herb R Harney 1968 337C Flying the same Skymaster for 47 years
|
|
#6
05-03-17, 08:21 AM
|
|||
|
|||
|
door trim
Appreciate the feedback but I'm assuming what was in there was some sort of nonstandard retrofit and have not located anything that would work. I found a satisfactory substitute however and may work well for someone else. The foam insulation for hot water pipes - carefully cutting a strip on the adhesive side around 1/2 inch wide worked quite well. The angle and slight curve of the adhesive side fit well and solved the problem.
|
Linear Mode
