|
Register | FAQ | Members List | Calendar | Today's Posts | Search |
|
Thread Tools | Rating: | Display Modes |
|
#1
|
||||
|
||||
An open letter to Aviation Enterprises.
My plane is now in being repaired.
This AD is very expensive in the neighborhood of $20,000. The damage to my aircraft as a result of the installation of the wing extension/fuel tank STC is extensive. The repairs are not only to comply with the AD but also to undue the damage caused by drilling into the spar caps. I gave Mr. Bell an opportunity to contact me to discuss remediation but he has not even acknowledged my e-mail. Mr. Bell, I know you read these posts? Now would be a good time to come clean and do the right thing. The damage caused by your STC is irrefutable. How can we continue to buy your other products if you are unwilling to stand by them? This is a wonderful opportunity for Aviation Enterprises to show the Skymaster community that they stand behind their products even to the point of making good on their errors. Hey, who doesn't make mistakes? Lets fix this one together so we can continue to enjoy our beautiful aircraft and Aviation Enterprises can continue to flourish with the confidence of the Skymaster community.
__________________
Gord C-FTES |
#2
|
|||
|
|||
Quote:
|
#3
|
||||
|
||||
Quote:
Was the modification to your aircraft done by Owen and his folks? I'm presuming it was based on your letter, but just wanted clarification. |
#4
|
||||
|
||||
Hi Larry I am pretty sure it was down by Owen but I will double check.
__________________
Gord C-FTES |
#5
|
||||
|
||||
Quote:
Have you heard back from Owen about this? Randy |
#6
|
||||
|
||||
Actually I have. I have since forwarded him all the repair estimates. Once the final bill is in probably early this week I will forward it to him along with wire instructions.
__________________
Gord C-FTES |
#7
|
||||
|
||||
Bills submitted
I submitted the final bill to Mr. Bell at Aviation Enterprises last Thursday November 25th.
$21,253.20 Canadian dollars. This included the repair as well as the cost to properly engineer the repair itself as it was far more than just filling a few holes and slapping some aluminum on the spar. Moreover, the repair to the lower skin was accomplished by removing the skin and replacing it as you cannot reinforce a hole that has a stringer running over it. It would result in an uneven finish. It was actually necessary to open up the top of the wing completely to get in and make the repairs. The shop spent 179 hours doing the repair and they even reduced their shop rate by 12% so they could keep to the estimate which I felt was very accomodating of them. If any of you need a similar repair they are called Aerostructural Inc. and their phone number is 866-971-5244. I also submitted all the work orders etc. and once I receive the funds I will release the balance of the engineering diagrams for his file on my plane. I have had a few back and forth emails from Mr. Bell. I believe he will do the right thing and remediate the damage. If there are any others out there I would be pleased to review my findings with you.
__________________
Gord C-FTES |
#8
|
||||
|
||||
Ae
Hi Folks, Been a while since I posted on the site here.
Have you every wondered why AE is not listed on this websites web page listing or about their past quality history? Reading about the quality of the wing extensions and the problems resulting from them made me wonder! Maybe you should too! Jerry |