Front and Rear Prop Spinners

[SkyMac]

Hi Ernie

Really appreciate the information, I will keep the option for carbon fibre units in mind. I am wanting to keep it original with metal spinners, polished.

This time I will polish them myself instead of sending them out !

Can I ask the for some additional information / assistance from the forum. We will be replacing rudder, elevator and trim tab bearings whislt it is apart.

The following are the P/N

MS24461-4 x 4
MS24462-4 x 4
PNA3 x 1

The cost of the MS bearings are $105 to $110 each from Yingling or Prefferd, no stock on the trim bearing, have any of our members found other sources of supply for new bearings?

If these are my only option then that's fine, but worth asking the question first.

Regards
Dave