[Roger]

Has anyone seen this happen before:
Gear up cycles until it is time for the rear doors to close. At that point they just stay open, and eventually the circuit breaker pops. Reset the breaker with the gear handle still in the up position and nothing happens, but eventually breaker pops again. Reset the breaker and put handle down, gear locks down and all doors close and lock. Tried it several times, and always the same thing.

I am assuming that the breaker pops perhaps due to a heat build up with the pump running for a minute or more?

Had it up on jacks and it will not repeat it in the shop.


1980 - 337H

Any help would be greatly appreciated

tks/Roger