View Single Post
  #1  
Old 05-16-18, 01:08 PM
cessnadriver cessnadriver is offline
Registered User
 
Join Date: May 2010
Location: Franklin, Pa.
Posts: 193
Interconnected elevator trim to flaps

Hello all.
During a pre-flight I noticed my elevator trim does NOT automatically roll forward while bring up the flaps with the trim wheel rolled full down position. I went through the manual re-adjusted the fitting that is suppose to bump against the elevator trim stops. Afterwards I re checked to see if the trim wheel moved forward as required. It did one time. After that the trim did not move as it should. Has anyone else had this problem?
Thanks in advance.
Regards.
BILLS

Last edited by cessnadriver : 05-16-18 at 01:10 PM. Reason: grammar
Reply With Quote