[basloane]

Hi Lucerne

I just saw your message ( after all these years.... ).

If you have been unable to find a pulley, you can try Tim Kasper at Kasper Industries in Gaylord Michigan.

He took over all the STCs a few years ago and he provided a pulley to me in 2011.

His email address is Tim Kasper <tkasper@kasperind.com>.

You may also wish to have a look at your engine mounts. My pulley was damaged when the ( old ) mounts became compressed enough to cause the pressurization relief cable to wear on the belt, and eventually the pulley.

Hope this helps.

Best Regards,........ Barry Sloane