Skymaster Forum  

Go Back   Skymaster Forum > Search Forums
Register FAQ Members List Calendar Search Today's Posts Mark Forums Read

Showing results 1 to 25 of 171
Search took 0.08 seconds.
Search: Posts Made By: Mark Hislop
Forum: Messages 04-29-14, 09:57 AM
Replies: 4
Views: 8,669
Posted By Mark Hislop
Spring Replacement

I had to do this a few years ago. If I remember correctly, I only had to remove the piano hinge from one side to release the hinge pin. I think it was the gear door side, but it should be apparent...
Forum: Messages 04-23-13, 10:03 PM
Replies: 7
Views: 11,490
Posted By Mark Hislop
I don't think you have a real issue. It sounds...

I don't think you have a real issue. It sounds like your electrical system is working. You just have a metering problem, and you are getting false indications. As far as I know, the parallel board...
Forum: Messages 04-23-13, 07:11 PM
Replies: 7
Views: 11,490
Posted By Mark Hislop
Although I could have eliminated the parallel...

Although I could have eliminated the parallel board (I installed a volt/ammeter) I left it in. I still like having the "idiot lights" in my scan.
Forum: Messages 04-23-13, 01:21 PM
Replies: 7
Views: 11,490
Posted By Mark Hislop
More than likely is that you've got a blown diode...

More than likely is that you've got a blown diode on the little signal processing board on the top center of your firewall. Or possibly a bad relay on the same board. The diodes are very easy to...
Forum: Messages 04-01-13, 10:49 AM
Replies: 4
Views: 11,937
Posted By Mark Hislop
She's going to be spectacular when all done.

She's going to be spectacular when all done.
Forum: Messages 04-01-13, 10:44 AM
Replies: 16
Views: 19,918
Posted By Mark Hislop
Thanks Herb. I didn't know that. Hopefully, Ed...

Thanks Herb. I didn't know that. Hopefully, Ed can find someone who is parting out a later model with the same tanks. Or get somebody to repair his tank.
Forum: Messages 04-01-13, 10:41 AM
Replies: 16
Views: 19,918
Posted By Mark Hislop
Hi Ed. If they were able to get the inboard tank...

Hi Ed.

If they were able to get the inboard tank in and out without removing the outer tanks, they are a lot smarter than I am. (Not a very high bar, I'm afraid.) I couldn't figure out a way to...
Forum: Messages 03-31-13, 08:40 PM
Replies: 16
Views: 19,918
Posted By Mark Hislop
Hi Ed. There is a guy on ebay who is parting out...

Hi Ed.

There is a guy on ebay who is parting out a 337D. I think the tanks are the same. Here is a link to one of his auctions for a different part, but you can find his contact information...
Forum: Messages 03-11-13, 09:51 AM
Replies: 3
Views: 8,956
Posted By Mark Hislop
An interesting comment by the seller...the engine...

An interesting comment by the seller...the engine has been stored since 1991. I would be very leery of internal corrosion some place, even though he says "it was oiled up". The pictures of it sure...
Forum: Messages 02-08-13, 03:25 PM
Replies: 8
Views: 13,939
Posted By Mark Hislop
The "V" style whisker antennas at the top of the...

The "V" style whisker antennas at the top of the vertical stabilizer on my Skymaster (and I suspect all others) are mounted differently than those shown in your photos. Each antenna (whisker) is...
Forum: Messages 02-08-13, 07:59 AM
Replies: 5
Views: 9,341
Posted By Mark Hislop
I have a 73 P337. Don't know how much different...

I have a 73 P337. Don't know how much different it is, but I would guess pretty similar except for the venturi coming off the intake system to feed the pressurization system. I am doing the annual...
Forum: Messages 01-06-13, 10:22 PM
Replies: 10
Views: 12,756
Posted By Mark Hislop
Sorry it took me so long to check, but I do in...

Sorry it took me so long to check, but I do in fact have a TSIO 360C6 engine on my 73 P337. It happens to be a Rolls Royce made under license from TCM.
Forum: Messages 12-23-12, 08:54 PM
Replies: 10
Views: 12,756
Posted By Mark Hislop
I'm pretty sure I did just exactly that about 10...

I'm pretty sure I did just exactly that about 10 years ago, when we discovered an unrepairable crack in the crankcase of my rear engine. My airplane is also a 1973 T337G pressurized, aka P337. It...
Forum: Messages 12-23-12, 12:49 PM
Replies: 10
Views: 12,756
Posted By Mark Hislop
Tsio 360c

There is a TSIO 360C. It is the same as the TSIO 360A, except rated at 225 HP instead of 210 HP, and has provisions for presurization.

TSIO 360 CB is an upgraded TSIO 360C with a modified crank...
Forum: Messages 10-15-12, 05:48 PM
Replies: 23
Views: 25,959
Posted By Mark Hislop
Hi Alex. I've been away for a while, and I just...

Hi Alex.

I've been away for a while, and I just saw your posting.

Like Ed, I am based at the Aurora airport. I have a P Skymaster, and I do most of the work on it myself (under supervision of my...
Forum: Messages 04-21-12, 06:38 PM
Replies: 18
Views: 21,187
Posted By Mark Hislop
Ed Just replaced one of mine. Original was cork...

Ed

Just replaced one of mine. Original was cork as was replacement. My old one had shrunk enough that the screws could be turned by hand. Only the safety wire was holding them in. The original...
Forum: Messages 04-19-12, 05:02 PM
Replies: 11
Views: 13,647
Posted By Mark Hislop
Flashing alternator lights is not an uncommon...

Flashing alternator lights is not an uncommon trait in Skymasters. It is usually caused by a high resistance point in your field wiring. The regulator senses field voltage to change alternator...
Forum: Messages 04-14-12, 11:50 PM
Replies: 4
Views: 8,767
Posted By Mark Hislop
Thanks very much Jim. That is exactly what I...

Thanks very much Jim. That is exactly what I needed. I really appreciate the help.

Mark
Forum: Messages 04-10-12, 10:27 PM
Replies: 4
Views: 8,767
Posted By Mark Hislop
Thanks Jim. I really appreciate it. My email...

Thanks Jim. I really appreciate it. My email address is mhislop@aol.com
Forum: Messages 04-10-12, 05:59 PM
Replies: 4
Views: 8,767
Posted By Mark Hislop
Fuel Gage Face

If there is anyone here who as a P Skymaster between s/n 001 and 0196, could you do me a big favor and take a closup picture of the face of one of your fuel gages? I sent my engien instrument...
Forum: Messages 03-31-12, 09:49 AM
Replies: 13
Views: 18,699
Posted By Mark Hislop
That's a great explanation of what goes on in...

That's a great explanation of what goes on in Center. Thanks Ed.
Forum: Messages 03-14-12, 12:27 AM
Replies: 14
Views: 16,365
Posted By Mark Hislop
Yoke Bearings

I don't think there is a search engine. I have found the parts there by using google, and his site shows up. I don't think he has a lot of Skymaster parts. The ones he does have I think are common...
Forum: Messages 03-12-12, 06:03 PM
Replies: 14
Views: 16,365
Posted By Mark Hislop
Yoke Bearings

The three small bearings that support each yoke at the panel in my 337 have lost their rubber coating. At least I think they are supposed to have a rubber coating.

In my aircraft, these bearings...
Forum: Messages 03-07-12, 09:43 AM
Replies: 2
Views: 8,388
Posted By Mark Hislop
Form 337

I already sent this to Tracy, but I thought I would post here in case anybody else wants the info. Attached is the form 337 for my aircraft for the installation of paralleled voltage regualtors. ...
Forum: Messages 01-25-12, 12:58 PM
Replies: 7
Views: 12,260
Posted By Mark Hislop
I would guess that the OV relay is causing the...

I would guess that the OV relay is causing the alternators to go off line. On my aircraft, it is located on the right side of the center pedestal, up high near the firewall.
Showing results 1 to 25 of 171

 
Forum Jump

All times are GMT -4. The time now is 04:06 AM.


Powered by vBulletin® Version 3.6.9
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.