Skymaster Forum  

Go Back   Skymaster Forum > Search Forums
Reload this Page Search Results
Register FAQ Members List Calendar Today's Posts

Showing results 1 to 6 of 6
Search took 0.07 seconds. Search: Posts Made By: Ernie Martin
Forum: Messages 06-29-12, 09:59 PM
Replies: 55
Views: 81,285
Posted By Ernie Martin
Kim, galvanized or stainless? And why? Ernie

Kim, galvanized or stainless? And why?

Ernie
Forum: Messages 05-14-12, 05:28 PM
Replies: 55
Views: 81,285
Posted By Ernie Martin
Both pieces of information are excellent. I think...

Both pieces of information are excellent. I think this seals it: choose standard steel, which I assume is galvanized.

Ernie
Forum: Messages 05-14-12, 02:19 PM
Replies: 55
Views: 81,285
Posted By Ernie Martin
Based on discussions on this forum, I believe the...

Based on discussions on this forum, I believe the consensus is to go with stainless. I believe that the principal cause of failures is corrosion. In later models, although the IPC still shows both...
Forum: Messages 05-14-12, 12:27 PM
Replies: 55
Views: 81,285
Posted By Ernie Martin
I see only 3 part numbers in the 1965 IPC figure...

I see only 3 part numbers in the 1965 IPC figure and parts table (relevant parts shown below). Note that in the table the penultimate column is "units per assy" and it shows 2 inboard actuator cables...
Forum: Messages 11-17-11, 03:17 PM
Replies: 55
Views: 81,285
Posted By Ernie Martin
Tony, that changes everything. Question: it was a...

Tony, that changes everything. Question: it was a thorough visual, with flashlight and cotton swab/rag? And showed nothing, no fraying of the cotton? If that is the case, then I retract my prior...
Forum: Messages 11-17-11, 10:31 AM
Replies: 55
Views: 81,285
Posted By Ernie Martin
Because some of the info on this thread did not...

Because some of the info on this thread did not conform with earlier knowledge, I spoke to Don Nieser about checking the cables.

It's true that a thorough visual and cotton swab/rag inspection may...
Showing results 1 to 6 of 6

 
Forum Jump

All times are GMT -4. The time now is 03:38 PM.

Contact Us - Skymaster Owners and Pilots Site - Archive - Top

Powered by vBulletin® Version 3.6.9
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.