View Full Version : rubber trim on 337p door needed
It's not the actual door seal, its the trim that goes between the interior plastic around the door and the metal door frame. I replaced the plastics but the foam trim molding is history and needs replacing.
hharney
04-06-17, 08:40 AM
Part number ?
I have searched my parts manual and have not found the part. I don't know if it is original or added along the way. It dense foam, triangular in shape about 1/2 inch each side. I've searched a number of manufacturers for something similar without much luck. It was glued to the metal door frame and spanned the gap to the plastic trim. Any help appreciated.
Can you post up a couple of pictures?
hharney
05-02-17, 05:50 PM
https://www.aircraftdoorseals.com/
Appreciate the feedback but I'm assuming what was in there was some sort of nonstandard retrofit and have not located anything that would work. I found a satisfactory substitute however and may work well for someone else. The foam insulation for hot water pipes - carefully cutting a strip on the adhesive side around 1/2 inch wide worked quite well. The angle and slight curve of the adhesive side fit well and solved the problem.
vBulletin® v3.6.9, Copyright ©2000-2024, Jelsoft Enterprises Ltd.